How to Properly Install Carpet Tiles

Chances are that if you are buying carpet tiles, then you already know that they are a lot easier to install then actual carpets. However you still want to do a good job and do it right, which is not a hard thing. There are a few things to keep in mind when laying down carpet tiles. You must remember checking out https://www.bestcarpetshampooerreview.com for some of the best carpet cleaners as well.

The first thing you want to keep in mind is your preparation before you start. Things like washing the floor and vacuuming are very important to ensure that the tiles stay attached to the floor. Make sure that you let the floor dry completely if you have washed it.

The next thing you want to do is find out where the center of the room is. The easiest way to do this is to snap a chalk line, which is where you put chalk on a string then snap it so that the string bounces of the ground and leaves a chalk line on the floor. Do this from one corner of the room to the opposite corner and then repeat it for the other line.

Now use a tape measure and tape and measure each of the four walls. Make a mark on the tape where the center of each wall is.

Snap another chalk line from one of the lines to the line on the opposite side of the room. If you have done this correctly you should have chalk lines that look somewhat like the union jack.

Take the tiles and do a rough layout on the floor of how the tiles will look. Put one tile at each 90 degree angle in the middle so that you have a square in the middle of the room.

Continue to lay the tiles out so that you have two small strips running from one end of the room to the other. Now stand at the door and take a look at it.

If you are thrilled with how it looks then you can take the adhesive pads that came with your floor tiles and begin to lay them down according to the instruction manual it should have come with.

You want to lay the tiles from the middle of the room out towards the walls. When laying the tiles push them close together, put the adhesive pad sticky side up and push down firmly.

To ensure your pads stay secured place the corner one tile on each corner of a pad. One adhesive pad should have four carpet tiles attached to it.

Lastly, when you get to the corners and have to cut them you should lift up the last tile you laid and place the tile to be cut face down and flush with the wall. Now with chalk draw a line on where to cut, then cut it and lay it down like you did to all the others